Contents [show]
A solid rod has a diameter of 20 mm and is 600 mm long. It is made of a material that can be modeled by the stress–strain diagram shown in the figure below. If it is used as a pin-supported column, determine the critical load.
Solution
Radius of gyration is
Slenderness ratio
Critical stress from Euler’s formula for K=1 pinned at two ends.\
Assuming that critical stress is in the elastic region σ_crit≤σ_pl=100MPa
σ_crit=6.847*〖10〗^(-4)*100 GPa=68.47MPa≤σ_pl=100MPa
SO
A copper bar with a rectangular cross section is held without stress between rigid supports. The tem...
Determine the minimum diameter of the rod. The axial tensile force is P=10KN. The allowable stresse...
The sudden change in shape of a structural component under a specific loading condition is called...
The constants and their correlations that are used to determine the behavior of an elastic material...
Determine the diagrams for moment and shear for the following pinned at two ends beam for a triangul...
Calculate the max stress because of torsional moment on the outer layer of a steel hollow rod when t...
A strain gage is located at D on the surface of the rod AB. The average normal stress on the rod is...